产品发霉后如何修复
产品发霉后如何修复
| 工作流程 Working process | |
| 一、作业前准备Preparation 1. 竹木防霉剂iHeir-PT 2. 喷壶Sprinkling can 3. 毛刷 Brush 4. 防霉除臭片Power Pak 5. 美工刀 Art knife 6. 新PE袋 New PE bag 7. 封箱胶 Scotch tape | |
| 二、操作步骤 Operation Procedure 1. 拆开纸箱：使用美工刀将封箱透明胶划开，刀片不可划破产品
1. Opening the Packaging box: cut the scotch tape with an art knife, and do not cut the product carelessly.
| 
|
| 2. 从纸箱中取出产品：产品轻拿轻放，不要损坏包装材料及产品 Taking out the product from the box: product should be handle with care. Do not damage the packaging box and product.
|  |
| 3.从PE袋中取出产品：注意产品轻拿轻放，不要损坏产品 Taking out the product from PE bag: pay attention to handle the product gently, and do not damage the product.
|  |
| 4.使用喷壶将iHeir-PT 喷于产品发霉处（木架与布料），用毛刷清理霉菌：产品轻拿轻放，霉菌清洗干净（注意产品缝隙处，彻底清除干净） Spraying iHeir-PT on the mildewed points(wooden support and cloth) with a sprinkling can ,then brushing the mildewed points: handle the product gently, and mildew should be cleaned and sterilized comprehensively(Pay special attention to the invisible seams and clean them thoroughly)
| 
|
| 5. 再次使用iHeir-PT全面喷涂产品，作防霉处理，并自然晾干。 Spray iHeir-PT on the surface of the product thoroughly for anti-mildew once again, and air-dry it.
| 
|
| 6.使用iHeir-PT喷涂纸箱内壁2-3下 Use iHeir-PT to spray the inner wall of the box 2-3 drops.
|  |
| 7.包装：将产品装入新的PE袋中，放入Power Pak（椅子底部），将产品按原样装箱打包 Packaging: update the previously used PE bag and put the finished product in it, and put a piece of Power Pak into the bag( under the wooden support). Pack the product as the original one.
| 
|
1. 在使用之前摇匀（表面有悬浮物属于正常现象）
2.该产品是安全环保的，但不排除个别人在皮肤接触后有过敏反应。因此，我们推荐使用橡胶手套来操作，如不小心溅入眼睛，马上用大量清水冲洗